Power supply unit for power LED
Power supplies for POWERLED for constant current driving (CDT “Current Drive Technology) and serial module connection. Typical driving currents are 350mA, 500mA, 700mA, 1A with an output voltage depending on number of modules and power supply chosen with a maximum of 48V.

Emergency Kit for Led fittings
Emergency Kit for Led fittings 1W x 3 Led - 3W x 3 Led - 1W x 9 Led - 3W x 9 Led - 220÷240V~ - 50/60Hz

SIRIO LED - VENERE LED
In SE-only applications LEDs offer better perfomances. With the same lumen/W the light is better used and, thanks to the high number of LEDs, it also provides even lighting.

Dimmer for DIMMABLE LED lamps
Recessed dimmer for dimming Led Lamps. Compatibility is guaranteed only with “LEUCI”, Lamps as from table 1. The minimum power is 4W and maximum is 75W. Direct command through deviator by pressure and regulation through rotation of the same handle grip; lighting and turning off through pressure of the handle grip.

Power supply units for
Signal LEDs (MINILED)
Power supplies for Signal Led “ MINILED” for constant voltage driving (or VDT ”Voltage drive Technology). Typical voltage values are 12V and 24V and the needed output power of drivers depends on number of modules.

Relco civil system
System for civil
and similar buildings

SURF
ASTRA
JOLLY
OLD STYLE

Electrical devices for domestic use
All the articles contained in this catalogue and that are within the meaning of the Directive 2006/95/CE (“BT” Low Tension Directive) are marked in conformity with the same regulations and can freely move in the Economic Community territory.

Industrial dimmer
The appliance allows continual variation of the voltage supplied to the device ‘s ends varying the effective value from zero to a voltage equal to 95% of the voltage power supply. It uses TRIAC (electronic switch) components that determine its maximum use power.

Three-phase transformers
Three-phase isolation/separation
transformers for photovoltaic systems